• Explicit initialisation of some I/O (port B) in case it does not start in default init state.

• Added some modifications to better support the XMP-1 signal format.
• Slight improvement in accuracy of de-modulated signal measurement.
• Can set a signal measurement fuzz value of zero, which removes all length comparison testing.

• Minor improvement to modulated signal output - removed the initial half cycle at the start of a modulated IR pulse.

• Signal output returns NO_SIGNAL_DATA error code if no data memory has been allocated.

• Long range detector disabled if the PC goes into standby. This should prevent the RedRat3 sometimes hanging when the PC comes out of suspend.
• Fixed a bug in keyboard signal type output.
• Added support for flash code signal output.

• Fixed very occasional bug in USB bulk out code in firmware. Downloading large signals sometimes caused a situation where packets were missed, resulting in a RedRat3 hang on next signal download.

• Added ability to change the minimum pause length. This allows applications to adjust the point at which a long length value is considered to be the intra-signal pause.
• Improved accuracy of signal sampling.

• Fixed bug in firmware causing sampling errors with signals that have a very long last pulse (>10ms), e.g. with some X-10 signals.

• Fixed bug in firmware initialisation code. This caused invalid data to be returned from the long-range remote control receiver if this was the first operation performed by the RedRat3.

• Fixed an occasional problem with carrier/modulation frequency measurement.

• Fixed a minor memory problem with IrDa-like signal memory allocation.

• Added support for output of IrDa-like IR signals used with Telewest and some NTL cable set-top boxes in the UK.

• Requires SDK version 0.12 or greater.
• Fixed a problem when sampling some signals with very short signal pulses, for e.g. Nokia Mediamaster 9850T.

• Fixed bugs related to concurrent IR input/output usage, i.e. it would still hang in certain circumstances.
• Better recovery following error conditions. These errors typically arise when the RedRat3 is hit by sunlight or some other IR source, maybe in combination with a valid IR signal.

• Note: This version of the firmware will only work with SDK version 0.12 or greater.
• Changes to support concurrent use of the RedRat3 by multiple programs.

• Improved accuracy of signal output pulse lengths.
• Improved accuracy of raw signal of measurement using the learning detector.
• Fixed small bug on signal output that sometimes caused a blip at end of the signal.

• Fixed bug causing hang when returning data of particular length, especially effecting Sony remotes.
• Changed pause length detection - now 18ms instead of 33ms. Benefits remotes with short intra-signal pause values, e.g. Sony.

• Memory allocation/freeing error with long range remote control detector input.
• Fixed a defect that prevented correct long range remote control detector input following signal output.
• Adjusted EEPROM access timing to prevent device hang on some versions of the USB chip.